Homebrew PCBs

I was actually going to post this info but had gotten busy.

This works great. I tried the transfer stuff from pulsar and it 
wouldn't work with my printer (brother). 
The traces would float right off the board, so I experimented with 
other papers.

I found that Avery shipping lables worked very well. Other than like 
you said where they are scored for peel off. I do really small boards 
usually so I would just work around them and am currently looking for a 
label type that the backing comes off in one piece.

About the laminator... I have one I got along with the TT paper and it 
works great with this very easy.

I run it 4 times length wise. I rotate it 180 every pass then drop it 
into cold water. The paper comes off real easy no scrubbing no BSing 
around at all.