Homebrew PCBs

Okay did some experiments with The Toner senstive foil. My general 
impression is that the toner needs to be really clean and that you 
need a lot of heat and pressure by that i means I had the laminator 
set to 250deg C. Just as a note I used a sheet of paper to protect 
the laminator rollers from getting stuck to the Foil. I have found 
that since switching to the laminator that i get far less problems 
with pinholes. perhapes it is because the laminator imparts far more 
pressure then I can with a clothes iron. I have also noticed that the 
film makes the edges of tracks rough and jagged which is not a 
particulary desirable effect. I do not surggest anybody pursues this 
as it give worse results then not haveing it.
--- In Homebrew_PCBs@yahoogroups.com, Markus Zingg <homebrew-pcb@...> 
wrote:
>
> Ok, the picture did not made it through. I created an album and 
uploaded 
> it to the photo section, but the group moderator first must aprove 
the 
> picture.... So you need some patience.
> 
> Markus
> 
> 
> peripherin schrieb:
> >
> > Now I am going to ask a question that I have tryed at before and
> > failed.
> > Does anybody know how to thru hole plate useing home equipment ? 
Also
> > any good websites would be welcome ?
> >
>