Homebrew PCBs

Stefan, Phill KAoHJBG, Leon and others that were intrested.

On Monday, February 23, 2009 1:21 PM I sent the below message

  ----- Original Message ----- 
  From: Stefan Trethan 
  To: Homebrew_PCBs@yahoogroups.com 
  Sent: Monday, February 23, 2009 1:21 PM
  Subject: Re: [Homebrew_PCBs] Re: Surface Mount


  I am using one mil copper.
  Will etch  a test board in a couple days and
  put it up for you to see.

  Derward

  I have been busy and just got around to doing it.
  Go to this site and see it.  Note that there are 4
  boards shown.  I did more but if I show more boards
  it is hard to se the traces.  Also the one labeld five mil
  is the three mill and the one labeled 3 mill is the 5 mill.
  http://www.denhamsprings.com/pcb_1mil.jpg

  Derward Myrick  KD5WWI



[Non-text portions of this message have been removed]