Homebrew PCBs

Folks, ya'll have talked so much about the great finish given by this tin stuff, I just might have to order a bottle - Any suggestions of a place to order from Alabama, USA? 

Cost for what size bottle? Typical cost per board spread over life of bottle?

Thanks for any info,

Ken H>

--- In Homebrew_PCBs@yahoogroups.com, DJ Delorie <dj@...> wrote:
>
> 
> Simao Cardoso <simaocardoso@...> writes:
> > HOT water rinse
> 
> Huh.  Cold seems to work just fine, though, but forgetting to rinse
> results in a horrible mess.  I'll have to re-read the directions on
> the bottle.
> 
> Then again, MG said their UV film wouldn't develop in sodium carbonate
> but that works just fine too.
>