Homebrew PCBs

On 04/07/2010 10:40 AM, awakephd wrote:

> I printed out both sides, put them together with the toner facing
> each other, and held them up to the light so that I could line them
> up exactly; then I stapled the sheets together, leaving room to put
> the board into the "pocket." I put the board in and ran this through

I tried this but I didn't get it aligned very well. Do you keep the full 
sheets or you trim them?

In this case, the size of the toner to transfer is almost as big as the 
copper board itself, so I had the added problem to properly "center" the 
toner on the board.


bye
as