Homebrew PCBs

not real sure of a rocker switch, have been looking online just by model numbers.  will look in past posts.  thx

--- In Homebrew_PCBs@yahoogroups.com, "sailingto" <sailingtoo@...> wrote:
>
> Is either of them the dual heat version with rocker switch for 3 mm and 5 mm lamination?
> 
> I don't remember for sure on the model numbers, but it does seem like one of those is the right one.  There was a post a month or so ago where the model numbers were covered.
> 
> Ken
> 
> --- In Homebrew_PCBs@yahoogroups.com, "dubob4432" <dubob4432@> wrote:
> >
> > i am looking for a GBC to modify for pcb transfr use and noticed there are quite a few different part numbers even for the same model.  anybody know the difference?
> > 
> > currently looking @ 1 that is model number 1701870 and also another that is model number 1701860, both listed as "heatseal 9" creative laminator",  both state 350W power.
> > 
> > will be using from 1/2oz to 4oz copper clad and thickness of .010 to .090 or so but most between ~.020-.060.
> > 
> > tia,
> > bob
> >
>