Homebrew PCBs

Just an update on this...

On 27/05/13 04:54, James wrote:
>  I've now undone them all and put them flat between some card and a 
> heavy thing in a warm place to see if there's any hope of resurrection 
> for my personal usage, but I doubt it somehow.

This does actually seem to have helped, there is less wrinklyness in the 
resist layer and I just successfully used a sheet with just a couple of 
touchups which perhaps partly was because I was too lazy to break out 
the laminator and just used a clothes iron to apply it to the 7x10cm 
board, and may have had the developer a bit strong too (my measuring 
style is "eh, that's probably about right").

But anyway, seems to be salvaged good enough for my personal usage, at 
least that sheet was.