Homebrew PCBs

I have brother lasers and I'm sure I did successfully use them for tonor 
transfer (but possibly it was an OKI), using contact adhesive book 
covering (polyproplene)... but with very varied results.  Frankly, a lot 
more variable than I could be bothered with.  Photoresist works much 
better.

The roll of book covering didn't go to waste though, when I print my 
artwork onto the tracing paper, I immediately stick a piece of the book 
covering over it before I do anything else, otherwise the tonor is too 
easily damaged on the tracing paper (especially when trying to align 
duplicate prints).

                             > Andrew Hakman wrote:
Pah, top posting, bottom    > Also, the whole issue with top
posting, both are old hat   > posting is dumb, because if every
I advocate SIDE POSTING     > one used a modern threading email

Let the debate about left or right side posting begin!