Homebrew PCBs

> 
> And PLEASE draw/describe what you want to build, I'm still not sure 
how to 
> make it.
> (Or if you finish fast some photos would do ;-) )
>
See:
http://webpages.charter.net/pminmo/holder.png

The sides are 3/16 pvc rods I bought from a hobby shop.  The 
plexiglass is 1/8" I made my verticle tank out of.  The idea is by 
laminating three pieces of plexiglas together with the center 
narrower than the 2 outside pieces will create a groove to hold the 
board in.  The bottom piece is fixed.  i.e glued to the rods, the top 
piece has two holes bored into so it slides up and down the rods.  
One side ot the plexiglass will be tapped so a nylon bolt can be hand 
tightened to hold the top section down depending on size of the board.

Phil