Homebrew PCBs

"Mark mlerman@... [Homebrew_PCBs]"
<Homebrew_PCBs@yahoogroups.com> writes:

> Did you check to be sure the carrier is grounded completely through the printing process? If the carrier is too short, it might be grounded when the leading portion of the pcb is printed, but not the bottom portion of the pcb. That is why I went from a 12 inch carrier to a 14 inch one.


Thank you for the fast reply.  Just now I tried clipping an aligator
clip on the back of the carrier and printing it again.  I ended up with
the same faded result.  I am using a 14 inch carrier like you described
in the guide.  I dont understand how the open source logo would come out
so black as in my first picture and so light in the second if it was a
problem in the length of the carrier.  Anything else I should try?


-- 
Matthew O'Gorman
BM: BM-2D7WS1iu3wNo66sLVwd4CcZ5sBHbn8CYwR
TorChat: 5w3dtk7nhkkijcpc
Site: https://b.rldn.net
Xim/Email: mog@...
mog@rldn:~$ fortune wisdom -s|boxes
/***************************************************************************/
/* Nasrudin walked into a teahouse and declaimed, "The moon is more useful */
/* than the sun."                                                          */
/*         "Why?", he was asked.                                           */
/*         "Because at night we need the light more."                      */
/***************************************************************************/