Yahoo Groups archive

Homebrew PCBs

Index last updated: 2026-04-28 23:05 UTC

Message

Re: My toner transfer experance

2016-01-01 by me@...

Use Scotch Brite pads before and after etching, I add a bit of hand soap. Scrub under running water.

Run the board through laminator at least ten time , flipping the board in every direction.

I print on wax paper. Tape a piece smaller than a sheet of paper to a sheet of paper. I have found Reynolds brand works the best.

Attachments

  • No local attachments were found for this message.

Move to quarantaine

This moves the raw source file on disk only. The archive index is not changed automatically, so you still need to run a manual refresh afterward.