Homebrew PCBs

yes. pcb quality should be talken about after etching.

From my experience, bad etching do happen even toner transfer is
looking good.



----- Original Message -----
From: "Stefan Trethan" <stefan_trethan@...>
To: <Homebrew_PCBs@yahoogroups.com>
Sent: Thursday, May 26, 2005 10:18 AM
Subject: Re: [Homebrew_PCBs] Direct printing


> On Thu, 26 May 2005 16:10:54 +0200, Alan King <alan@...> wrote:
>
> > Stefan Trethan wrote:
> >
> >>
> >   Just found my foil and did a large test.  One letter 'i' didn't make
> > it,
> > likely due to the wrinkling of the foil.  99% success on a 6"x6" piece
> > of foil.
> >   Had a minor problem or two with smaller pieces the first time,
> > wouldn't have
> > expected something this large to do as well.  Still should have tried it
> > back
> > then just to see though.  I think I know what I'm doing this weekend
> > now..
> > Alan
>
>
> even without the HV working ~50% are transferred just by chance.
>
> Still, i do not think it will work. If you show me a picture of a direct
> printed PCB (actually etched), then i will say you were right, otherwise i
> will say i told you so ;-)
>
> ST
>
>
>
> Be sure to visit the group home and check for new Bookmarks and files:
> http://groups.yahoo.com/group/Homebrew_PCBs
> Yahoo! Groups Links
>
>
>
>
>
>
>


__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com