Homebrew PCBs

Robert Hedan wrote:

> Alan, I see a problem with this idea.  How are you going to support the PCB
> in place?
> 
> I was planning on using this design:
> http://www.vertice.cl/cnc1/
> But with the gantry center-mounted for more surface coverage.
> 
> I would have to place the rods at the extremities of the sliding platforms,
> I can do that.  I'd have to place the screw along one side, I can do that
> too.
> 
> But what about the bottom block?  How do you get it to come up right
> alongside the via bole, the platforms are going to be in the way?  I was
> thinking of using a variable-dimension forcefield to hold the PCB in place,
> waaaaay easier.
> 
> Robert
> :)
> 

   Nope, bottom block is fixed, top block is fixed right over it.  Wire feed is 
just in front of the top block.  Board is held at two edges, there is nothing 
above or below the board.  Via taken to wire insertion, moved slightly to the 
back so block corners catch it, knife cuts parallel to board and cuts against 
top block.  Once cut move back just a bit more to finish the top and bottom 
bends, then on to the next via.

   You need a diagram more than words, what I have in my head is very simple, 
it'll obviously work..

Alan