Homebrew PCBs

--- In Homebrew_PCBs@yahoogroups.com, Robert Hedan
<robert.hedan@v...> 
wrote:
> There are 6 wires on a unipolar motor, 2 sets of 3 wires.  The 
center wire
> of each set appears to be a common power source.  But how do you go 
about
> deciding the order of the other wires in relation with the
schematic?

There is a lot of information about stepper motor wireing including
an 
online "expert" system that helps you figure out the wireing based on 
resistance measurements between the wires at

http://www.piclist.com/techref/io/steppers.htm