Homebrew PCBs

 Subject: Re: [Homebrew_PCBs] Re: Drilling circuit boards on the cheap: [3 Attachments]
 To: Homebrew_PCBs@yahoogroups.com
 Date: Wednesday, February 17, 2016, 9:21 AM
 
 
  
 
 
 
   
 
 
     
       
       
       
   
   
     Before a friend ham wanted to throw it to the scrapyard,
 I could get
     a hold on it. The needed trafos for the spindle motor
 and the bulbs
     were just hanging around so I made an aluminum case to
 hold them.
     The spindle height lever automatically switches the
 spindle on as
     soon as lowered. May be someone gets some ideas to make
 his own.
 
     
 
     Jean-Claude, HB3YDH
 
     
 
     
 
     
 
     
 
     
 
     Am
 16.02.2016 um 15:57 schrieb
       wb8nbs@...
 [Homebrew_PCBs]:
 
     
     
  
       
           
             This is what I use for small boards. It only
 has about an
               inch and a half throat but is very stable. I
 think it was
               used by clock makers but there is no
 information available
               for it.
           
           
           
           
 
         
       
     
     
 
   
 
 
 
     
      
 
     
     
 
 
 
 #yiv9597788418 #yiv9597788418 --

>
> That is very simillar to the one I made, see:
> <https://www.youtube.com/watch?v=AhlRkO0EcFo>
> https://www.youtube.com/watch?v=AhlRkO0EcFo
>
> Malcolm
>
> I don't suffer from insanity I enjoy it!
> Mene, mene, tekel, upharsin
> The writing is on the wall.
> Ha-ktovet al ha-kir
>
> --------------------------------------------
> On Wed, 2/17/16, 'casy_ch@...' casy_ch@... [Homebrew_PCBs] 
> <Homebrew_PCBs@yahoogroups.com> wrote:
>
> Subject: Re: [Homebrew_PCBs] Re: Drilling circuit boards on the cheap: 
> [3 Attachments]
> To: Homebrew_PCBs@yahoogroups.com
> Date: Wednesday, February 17, 2016, 9:21 AM
>
>
> Before a friend ham wanted to throw it to the scrapyard,
> I could get
> a hold on it. The needed trafos for the spindle motor
> and the bulbs
> were just hanging around so I made an aluminum case to
> hold them.
> The spindle height lever automatically switches the
> spindle on as
> soon as lowered. May be someone gets some ideas to make
> his own.
>
>
>
> Jean-Claude, HB3YDH
>
>