Mark, Don and anyone else who is
interested,
The Davis show is on
Sunday, not Saturday.
Mike Denman
Chassis # 4079
----- Original Message -----From: mcaqmdSent: Tuesday, April 23, 2002 8:58 PMSubject: [MarcosManiacs] Re: looking for rear brake cylindersMark,
I looked in my spares and all I have is 7/8" and 1" rubber seals. My
rear brake cylinders are 3/4" also. Any foreign auto parts store
should have Girling kits. I ended up getting Volvo kits at the local
shop. Just have them look up brake kits and get a 3/4" one. The
seals are all about the same. I used a brake master cylinder 3/4"
seal to replace my clutch slave cylinder seal?!
Good luck! Hope you can make Davis show on Saturday.
Don Lattimer
#3m5759 V6
--- In MarcosManiacs@y..., markwoof92@a... wrote:
> Hi Don.
> What is the bore on your cylinders?Mine is 3/4 inch but I am not
sure that
> this is the correct bore .And what do the rest of you all out there
say?
> Mark P.
To unsubscribe from this group, send an email to:
MarcosManiacs-unsubscribe@yahoogroups.com
Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.