Modular Synth Panels

Sorry for not getting back to you on that one. Been sick all week.  
Blech!

Scott Deyo
contact@...
The Bridechamber
www.bridechamber.com
Jealous Edison Record Kompany
www.jealousedison.com




On Sep 22, 2009, at 3:00 PM, James Elliott wrote:

>
> Here's the response I got from Ian.
> ---------------------------------------------------------------------------------
> Sorry for the confusion.
>
> For R24a and R24b, their cw terminals are connected to J2 (pins 10  
> and 12).
> Their sliders are connected to their ccw terminals and additionally  
> to the cw terminals of R25. These connections are made on the panel,  
> as indicated by the "on pan" label on the schematic.
>
> For S1, the range is low when open (as drawn) and high when shorted.
>
> Hope this is clear now. It might help you to mark the cw and ccw  
> terminals on the panel and to make a little sketch of the wiring  
> before you start soldering. (I think that's what most of us end up  
> doing to keep from getting confused.)
>
> Don't hesitate to ask if you have more questions. I know that my  
> minimalist notation is sometimes confusing to some people.
>
> From: James Elliott <johans121@...>
> To: ModularSynthPanels@yahoogroups.com
> Sent: Tuesday, September 22, 2009 12:20:57 PM
> Subject: [ModularSynthPanels] ChaQuo Wiring Question...
>
>
>
> Ok.... so I'm a bit of a moron, so I have to ask...
>
> How do I wire up R24 (dual ganged QO Fine Tune pot) and S1 (High/Low  
> Range switch)?
>
> For R24, the schematic only shows CW being connected...
>
> For S1, is High when the switch is closed, or is Low when the switch  
> is closed? Or.... does S1a have to be closed and S1b open for high  
> (or vice versa)?
>
>
>
>