PLAN B analog blog

Yess this helps much!

Merci Peter :)

g.

--- In PLAN_B_analog_blog@yahoogroups.com, "(i think you can figure 
that out)" <peter@...> wrote:
>
> The Power system has had a couple of upgrades since Alessandro 
first
> took possesion of the system, but currently it's powered by a 1.7 
amp
> Power One supply which is mounted in the case behind the lower 
right
> modules.
> 
> Power distribution is handled via a long linw of Plan B Model 1 
boards
> mounted on a single Vector rail which runs across the length of the
> chassis at the center, hung about 4 inches from the back of the
> modules and bolted to the front rail by a series of standoffs.  
This
> way it's not directly connected to the case wall and is somewhat
> protected from bumping due to that.
> 
> the rails are Vector T struts. Do a search in this blog - they're
> mentioned a few times on in this group. They are svailible at 
Mouser
> 
> hope this helps,
> 
>  P
> 
> --- In PLAN_B_analog_blog@yahoogroups.com, "gabu_004" <gabu_004@>
> wrote:
> >
> > Hello Peter,
> > 
> > I'm woundering how does the power distribution works in the NIN 
custom 
> > case and what type of power supply is being used...
> > I mean I'm planning to build myself a roadcase/modular synth and 
I'm 
> > trying to avoid buying doepfer's bus board to reduce as much as 
> > possible the building cost... Also what is being used for the 
railing 
> > there?
> > 
> > Thanks
> > 
> > g.
> >
>