PLAN B analog blog

Nope! (linking two together for 16 steps).  With the upcoming M34
Switch Logic, or any other sequential switch for that matter you can
do that but on their own.. no.  Again, this is a bare-bones sequencing
function with voltage control of direction which you'll really get use
out of.  You don't realize it until it's there.

It will run about $300 or so, somewhere in this range.  As always,
less if I can do it. As far as ETA all I can say is before the Fall. 
I don't mean to be evasive, but my whole life right now is about the
ELFs.  Once they're released, then I begin the final preps on the
other ones. Got our hands full though with the first phase.

- P


--- In PLAN_B_analog_blog@yahoogroups.com, "elemental"
<adam.elemental@...> wrote:
>
> 
> Sounds good!
> Hoping to get a Mini-Milton or 2 to complement the Frostwave Fat
> Controller I recently found on eBay. Is there an estimated price tag
> yet? ETA?
> 
> It looks wicked, loving the circular design. I assume it would be
> possible to link 2 up so that you can construct a 16-step sequence?
> 
> Thanks
> Adam 
> 
> --- In PLAN_B_analog_blog@yahoogroups.com, "(i think you can figure
> that out)" <peter@> wrote:
> >
> > Along with the individual stage gate outs, the Mini Milton is equipped
> > with with a single Obedient Clock output.  This is a trigger which
> > follows the external input clock, but only when the sequencer is in
> > motion (when the counting is stopped by either an external source
> > using the ext stop input  or depression of it's Start/Stop switch, the
> > Obedient clock stops as well).
> > 
> > So this addresses if it has a single summed gate out.
> > 
> > As to why it doesn't have switches on each step which determine which
> > stage passes a gate out of the Obedient Clock output, it was simply a
> > matter of panel size.  The intent of the Mini Milton was to provide an
> > affordable single bank sequencing function.  While it would be
> > perfectly acceptable to design a system which had a 21C as it's
> > only sequencer, the 21C provides a means to introduce multiple
> without a large investment of $$ or panel real estate in which to do
> it. That was the real intention in developing the 21C.
> > 
> > I made a determination that individual gate outs was the best
> > alternative given the panel space available to add them As a note,
> > there is not enough room to mount switches into these locations.  A
> > matter of fact Cliff Jacks won't even fit there (my new type jacks
> have a much smaller profile under the faceplate).  So between having
> > individual gate outs or switches to gate which stage passes a gate to
> > the Ob Clock,  the former took precedence.
> > 
> > 
> > - P
> > 
> > 
> > 
> > --- In PLAN_B_analog_blog@yahoogroups.com, "monroeeskew"
> > <monroe.eskew@> wrote:
> > >
> > > Sorry if this has been asked before...
> > >
> > > Can you explain the rationale behind having a separate gate output
> > for each step in the
> > > cycle, rather than having a single gate out and gate switches for
> > each step?
> > >
> >
>