QTR-Quadtone RIP

If you are using QTR, be sure the C or M ink limit is set low enough that
it's maximum density at its ink limit is well below the dmax of the MK.
 You might also want to use the Black Boost for the last 10% of the MK ink
curve.  When you use the Boost, the second calibration print is done at the
K ink limit, not the Boost setting.

Paul
www.PaulRoark.com

On Sat, Feb 23, 2013 at 12:21 PM, rossfmj <ross.jarvis@...>wrote:

> **
>
>
> I can't get linearised profiles to install for UT14 on Hahnemuhle Photo
> Rag Bright White. I am getting the message "Invalid linearize curve -- not
> constantly increasing". This is happening on both a warm and a cool profile.
>
> The linearisation density values for both do constantly rise, however the
> paper white and 5% values are low and close, 0.02 and 0.04. When the script
> runs in terminal, the line of numbers underneath the linearisation values
> has 100 twice at the end for both profiles. The graphic curve
> representation ( lines of ****) also has lines (values) 244 and 255 near
> equal or equal.
>
> Any ideas or advice?
>
> Ross
>
>  
>


[Non-text portions of this message have been removed]