QTR-Quadtone RIP

I'm printing on 13x19, using Selenium K7 inkset on an R2000. My first print worked just fine, but a smaller print on the paper. I selected it to print .5" from the top, and it used less than half the sheet.

Next I tried to print a full size print on the 13x19 and the printer ejects the paper. I'm selecting QuadR2000-K7, 13x19, sheet feed, matte paper, c centered and to fit. I'm using the K7-2880-Epson EnMatte, and printing on Epson Enhanced Matte paper. I'm using a resolution of 2880 dpi, unidirectional.

Has anyone experience this and have a solution?

Larry

Once again, I seem to have found the solution.  I reduced the size of the print just a little.  Instead of using "to fit", I unchecked the box and reduced the size until the border was about .5".

Larry
--------------------------------------------
On Sun, 5/29/16, pianoquartet@... [QuadtoneRIP] <QuadtoneRIP@yahoogroups.com> wrote:

 Subject: [QuadtoneRIP] 13x19 on R2000 ejects paper
 To: QuadtoneRIP@yahoogroups.com
 Received: Sunday, May 29, 2016, 1:31 PM
 
 
  
 
 
 
   
 
 
     
       
       
       I'm printing on 13x19, using
 Selenium K7 inkset on an R2000.  My first print worked just
 fine, but a smaller print on the paper.  I selected it to
 print .5" from the top, and it used less than half the
 sheet.Next I tried to print a full size
 print on the 13x19 and the printer ejects the paper. 
 I'm selecting QuadR2000-K7, 13x19, sheet feed, matte
 paper, c centered and to fit.  I'm using the
 K7-2880-Epson EnMatte, and printing on Epson Enhanced Matte
 paper. I'm using a resolution of 2880 dpi,
 unidirectional.
 Has anyone experience this
 and have a solution?Larry
 
     
      
 
     
     
 
 
 
 #yiv0472545434 #yiv0472545434 --