QTR-Quadtone RIP

I have recently installed Quadtone RIP on a Mac Pro using an Epson
7600 and OSX 10.5.6.

When using A3 centered, the image (14in x 11in) is always 1cm closer
to the top edge? Apart from manually changing the layout, is there a
way to fix this?

It was working fine on my laptop with osx 10.4 with an earler version
of quadtone RIP (the one with two tone curves, not 3)

Using Mac 10.5.6, QTR 2.6.2, CS4, photo rag 188 and A3 centered, but
print is 2cm high and 2mm to the left on the paper - is this another
CS4/OSX 10.5 issue or is something else going on?

--- In QuadtoneRIP@yahoogroups.com, "natcarish" <natcarish@...> wrote:
>
> Using Mac 10.5.6, QTR 2.6.2, CS4, photo rag 188 and A3 centered, but
> print is 2cm high and 2mm to the left on the paper - is this another
> CS4/OSX 10.5 issue or is something else going on?
>
Similar things happen with many Epson/Adobe/Mac combos in that, at the Page Setup menu boxes, the middle box (Format For) defaults to Any Printer.  Check that your printer 
(Quadxxxx) is chosen and see if that helps.  The same problem can come up with the Epson drivers and many times things will keep defaulting back to Any Printer.

I've checked and it's definitely set right for QTR - this problem has only appeared since upgrading to CS4 and Leopard

--- In QuadtoneRIP@yahoogroups.com, "robert49brake" <robert49brake@...> 

> Similar things happen with many Epson/Adobe/Mac combos in that, at the Page Setup menu boxes, the middle box (Format For) defaults to Any Printer.  Check that your printer 
> (Quadxxxx) is chosen and see if that helps.  The same problem can come up with the Epson drivers and many times things will keep defaulting back to Any Printer.
>