Attachments :
-------------- Original message ----------------------
From: "derwskee" <synpro@...>
"On your Slope that cuts out, there is a trade off with the
way its single trimmer is set because the output amplitude
and frequency are interactive. I can reduce the frequency
and it will, in turn, change the cut out point -- but it won't
make it go away completely, just shift it to a different part
of the Slope's operating range. [It] has a 10,000 /1
exp sweep to it and when the integrators IC reaches its input
voltage limit, it latches up. It won't hurt anything, but it has
to be retriggered to get that IC going again."
From: "derwskee" <synpro@...>
> Had a question regarding audio rate modulation of the Dual UniversalYes, I asked Rex about this and I hope he won't mind me quoting him but it's precise:
> Slope Generator or Dual Transient Generator...
> 2) Anyone else notice that it (Dual Trans) will stop oscillating when
> being modulated like this?
"On your Slope that cuts out, there is a trade off with the
way its single trimmer is set because the output amplitude
and frequency are interactive. I can reduce the frequency
and it will, in turn, change the cut out point -- but it won't
make it go away completely, just shift it to a different part
of the Slope's operating range. [It] has a 10,000 /1
exp sweep to it and when the integrators IC reaches its input
voltage limit, it latches up. It won't hurt anything, but it has
to be retriggered to get that IC going again."