you can get proper isa prototype pcbs:
this one is far too expensive, but maybe your local bricks and mortar electronics shop has some left over from the old days.
ewan.
On 3 February 2017 at 16:34, hr.public@... [Simmons_Drums] <Simmons_Drums@yahoogroups.com> wrote:
Moving this project slowly forward I've might have found a way not to solder to my SDS7 before absolutely necessary. I've ordered one of these 3$ ISA diagnostic card one stick inside an old computer. Plan is to blow my heat gun to it and brush off components, cut a few traces and I believe it could serve as a pcb edge connector for SDS7. http://www.ebay.com/itm/271890921827
I'm also ready sorting out pins for a SD card test http://snw.lonningdal.no/sds7eprom.php#sdcard
As always, don’t hesitate to point out faults and errors, ask question or requests.
hans