Analogue-sequencer

> Do you always get the bad block flag if you try sending the dump
> again ?
> If you always get it around the same time, there could have been an
> error in the reception of the dump at your PC 

I get it all the time. Midi transfer continues...
Even after removing R3, I get the message alternating with a checksum 
message I guess. It changes so quickly. But I can clearly see the end 
X.  When it ends I see the checksum message. (before removing R3 it 
ended withe the bad block message) Transmission was OK now.  This is 
when receiving Sysex so not during a build send. I'll try some more 
tomorrow.

> When I finally get things sorted so I'm not building them myself,
> maybe I can get round to that 'proper' librarian utility that'll use
> the handshaking messages to guarantee a successful transfer...

Would be nice ;-)

> > Is there a way to
> > check what version I'm running, At start up it shows 398. Does
> this mean
> > 3980 or 398(I don't show you)?
>
> If you hold FUNC+PAGE at power-on to enter firmware update, you'll
> see a 4 digit hex checksum.

8DF0

> The checksum is the only way to tell for sure which build you have
> running. But I don't have a copy of the 3.981 or 3.980 syx files
> here, or a note of what the checksums were. Can anyone else oblige ?

Anyone?

Tom