Analogue-sequencer

> Is it possible to give the P3 a 48 ppq sync out, for I red somewere
> that the P3 runs internally on 48 ppq, or is it possible to program
> the m2d2m to make a clock signal of 16 or 48 ppq and how should I do
> that?

The PIC used for m2d2m doesn't have enough power to do clock doubling, so
that's out.
P3 does indeed run at 48ppqn internally. The 24 ppqn sync output is
generated by turning the din clock pin on then off at alternate clock
pulses. To have it turn on at each clock pulse, then off after a short
delay, I'd need to use a timer to signal the end of the pulse. This could be
done using the timer that updates the LEDs and scans the keyboards.
I'll look into adding it as a user config option.

Cheers,
Colin f



________________________________________________
Message sent using UebiMiau 2.7.2