Analogue-sequencer

Hi Hans,

> Why every pattern has a different midi channel  eg, pattern 3; channel 3,
> pattern 7 channel 7, Where is the goblal midi page?  I want an omny mode.

This sounds like you have confused tracks and patterns in the same way Boele
did - we discussed this recently on the group.
See:
http://launch.groups.yahoo.com/group/analogue-sequencer/message/1601

> When I choose other pattern than 1 in pattern edit mode, that pattern has
> only one step, What Am I doing wrong?

Did you perfom a memory initialise first time you started P3 ?
This needs to be done to clear all the global settings, although a bank init
on every bank should do the same thing.

> The tie function seems not working exactly like the 303 or 202 , all the
> steps gets triggered instead of a tie

There is no intrinsic 'tied note' message in midi - tieing two notes
together means the note off for the first note is not sent until after the
note on for the following note - the notes overlap. In most synths working
in mono-mode, this means the two notes will be played legato. If your synth
(or CV convertor) support 'auto' (i.e. legato) glide, then it will perform a
303 type slide. You need to have triggering set to single trigger too.

Hope this helps...
Colin f



________________________________________________
Message sent using UebiMiau 2.7.2