Analogue-sequencer

Julian,

> The update itself was somewhat odd.  Not only did i have to wait a good
> minite plus for the "boot" "flash" commands to appear under
> the "Checksum = ...." mssage on boot, i had to increase the delay in
> midiox up to about 500ms to aviod bad transfers....

There's nothing in the code to make it pause there. Very odd...
Anyone else seen that ?

> Another irritation, thats been in place since the beginning, but id just
> kinda accepted it:  if i ever start editing a new track,
> setting the direction, initially i have to scroll along through a load
> of CC stuff.  When ive scrolled (ie using the f1 button) back
> enough i get onto the directions, and then when these loop arround
> again, theres no mention of CCs ever again.  Just somthing worth
> mentioning, i guess.

The CC string contants are stored after the direction strings.
Seeing CC names as directions means you probably haven't done a memory
initialise first time you powered up P3. A bounds check there would fix
that, I'll add one in.

> Normally when i turn on the p3, it comes on instantly.  But then
> occasionaly theres quite a pause...

Hmm. There shouldn't be. I'd suggest checking the reset cap is the right
value and orientation, but I can't remember off the top of my head what
designator that one is. It's the 10uF electolytic to the immediate left of
the CPU. Also check the soldering and values of the caps and crystal.

Cheers,
Colin f



________________________________________________
Message sent using UebiMiau 2.7.2