Analogue-sequencer

Sorry if this has been asked or is somewhere in the manual but i have 
searched with no luck :(
I just wnated to check how i return a sequence to 'normal' after using 
say a note accumulator.
a simple example would be if i turn on a note accumulator on step1 and 
set it to one...this casues the sequence to rise a note everytime it 
passes step 1 so on ever pass it gets higher and higher.
Where i am lost if say after 5 passes of step one i then turn it off 
the sequence remains at the new pitch and does not return to normal.

I'm assuming it can easily be reset rather than having to wait for it 
to cycle through enough times to drop back down to normal pitch but 
for the life of me i cant find it.

I think i also had a similar problem with an aux set to change the 
time from 32 to 64 etc on certain sections. so for example the sequnce 
runs at 64 from step 1-10 (step one is the active aux step set to 64) 
and then step 10 changes it back to 16 again until it hits step 1 
again and returns to running at 64.
The problem i found was that without activating one step set to 16 
when i turn the aux events off on the steps the seqeunce keeps running 
at whatever speed the last active step set it at. so in this example 
if i turn off the time changes at steps 1 and 10 and the sequence was 
at step 6 when i did it the sequence continues to run at 64?

sorry if these have been discussed but i have searched and now that im 
seriously getting into the P3 its a little frustrating at times.

thanks
Brett