Bc2000 (for the BCF2000 & BCR2000)

thanks steve you were right about midi ox. that fixed it. ableton is unable to forward sysex messages. thanks again. for quick reply.

richard.

--- In bc2000@yahoogroups.com, sghookings@... wrote:
>
> If I understand your signal path,
> 
> BCR (MIDI OUT) -> (MIDI IN ) TX cool
> BCR (MIDI IN ) <- (MIDI OUT) TX cool
> 
> I am guessing maybe in S1 or S3 mode
> 
> When you connect via USB you have to be in U mode.
> U1 or U3 just as an example (there are 4 modes)
> 
> 
> Something like 
> BCR -> USB -> sequencer -> USB -> BCR
> 
> And with extra midi channels in sequencer pumping midi to the tx. can work but the sequencer needs to echo the midi thru. And what are the signal paths to/from kit. And probably you need to choose channels carefully.
> And careful ... you can create midi feedback loops which will crash the bcr. Reboot bcr and it should be fine.
> 
> So perhaps draw out what you want to achieve.
> In doing that recall about channels ... what midi channel is tx programmed on?
> 
> Once you drawn a diagram and made a few attempts, post either an ASCII picture or stash a simple diagram in the files section and repose the question , but I think when you draw it out you will understand who isn't passing the message on, and rectify it.
> Using midiox can really help here (strong hint).
> 
> Regards
> Steve H
> 
> 
> --- In bc2000@yahoogroups.com, "darealproductions" <darealproductions@> wrote:
> >
> > i think i need to rephrase.... i dont think i made my self clear, sorry...
> > 
> > when i connect the bcr directly to the tx81z works fine. when i passthrough any sequencer it filters it all out. is the preset only for direct connection??
> > 
> > --- In bc2000@yahoogroups.com, "darealproductions" <darealproductions@> wrote:
> > >
> > > hi guys,
> > > 
> > > great thread. i have been tinkering with the tx81z preset for the bcr2000 and its great. the only problem is it would really be usefull if i could send the messages on usb to ableton then reroute back to the synth. is this possible. i had a look at the preset in bcmanager but could not find any clues as how to set to go through usb! is this atall possible? when i select usb out from the bcr ableton does not recognise anything at all. no midi input. but when i select s1 upwards no problem...
> > > 
> > > thanks to all in advance
> > > 
> > > Richard
> > >
> >
>