Bc2000 (for the BCF2000 & BCR2000)

sorry made a mistake with the code.
its EN12-HS 2 0 A F 25 or 30 not sure bout the length but T needs to be 12.

Am 26.11.14 21:46, schrieb jb aomusik@... [bc2000]:
>
> hey.
> i�ve been looking into that quiet often .
>
> 1. replacement is not straight forward as the pots are soldered into the
> ledring�s housing and hard to reach. desoldering those encoders needs to
> be done with a lot of care as not to damage the circuit board itself.
> best bet is to clip them of from the top (inside the ledring�s housing)
> , then carefully use solder braid from the bottom side and finally a
> suction pump to get the remainig bits out of the holes. clean with
> aceton or isoprop.
>
> 2. the encoders itself are alps.
>
> http://www.alps.com/prod/info/E/HTML/Encoder/Incremental/EC12E/EC12E_list.html
>
> but have special specs that are not available on website.
>
> find some 12mm ( 12mm x 15 mm) encoders without bushing, 24 to 30
> positions, without detend , total length shaft and house 30mm , d-type
> flatted shaft. and you are good to go.
>
> theres some with bushing here ( they might fit even with bushing ) :
> http://www.bitechnologies.com/pdfs/en12.pdf
> code: EN12 - VS 2 0 A F 30
>
> if you still have warranty on yours - send it back. this will be way
> more easier!
>
> check this to get some views from inside :
> http://www.knutsel.org/2010/09/14/behringer-bcr2000-2/
>
> good luck.
>
> j.
>
>