In a message dated 9/29/2005 9:55:17 PM Central Standard Time,
chonald@... writes:
Start out here: http://larry.retrosynth.com/larry/panel.htm
Then look here: http://larry.retrosynth.com/larry/panel/gif.htm
For custom panels: http://www.hotrodmotm.com/
There is an upcoming panel run so your timing is good. Stooge panels are
MOTM format. I can tell you these panels are first-rate quality-wise. If you
want, I believe there is even a drilling service available. I too will be
ordering some panels for CGS products this run. "Stooge" Larry is about the nicest
and easiest person with whom you can work. Highly recommended! "Stooge" Moe
(aka Dave Bradley) also does custom panel layouts for a very nominal fee.
Also, a really nice person. First-rate products from first-rate people at a
very low cost.
What more could one ask for? You want more ... okay, then check out:
http://larry.retrosynth.com/larry/bracket.htm
Mounting brackets for PC boards. Rugged and perfect for all sorts of DIY
efforts. Larry has brackets to mount PCBs on pots, jacks, and all the odd bits
to mount just about any PC board to anybody's panels. "Stooge" brackets work
great on Frontpanelexpress panels, too!
As you can tell I am a big fan, satisfied customer and repeat buyer! Others
on this list will tell you the same thing. MOTM-900 will work fine with the
CGS boards I have seen. I only have the CGS29 and CGS38 boards so far, but
they'll mate up to a 900 without issue. Others more qualified to speak can tell
you about compatibility with other CGS boards. I would guess there is no
issue at all.
Peace.
Tom Farrand
[Non-text portions of this message have been removed]
chonald@... writes:
> Is there anywhere, recently, that is selling front panels (MOTM orCole,
> Synthesizers.com format) for the CGS?
>
> Would a MOTM-900 power supply run the CGS modules?
>
>
Start out here: http://larry.retrosynth.com/larry/panel.htm
Then look here: http://larry.retrosynth.com/larry/panel/gif.htm
For custom panels: http://www.hotrodmotm.com/
There is an upcoming panel run so your timing is good. Stooge panels are
MOTM format. I can tell you these panels are first-rate quality-wise. If you
want, I believe there is even a drilling service available. I too will be
ordering some panels for CGS products this run. "Stooge" Larry is about the nicest
and easiest person with whom you can work. Highly recommended! "Stooge" Moe
(aka Dave Bradley) also does custom panel layouts for a very nominal fee.
Also, a really nice person. First-rate products from first-rate people at a
very low cost.
What more could one ask for? You want more ... okay, then check out:
http://larry.retrosynth.com/larry/bracket.htm
Mounting brackets for PC boards. Rugged and perfect for all sorts of DIY
efforts. Larry has brackets to mount PCBs on pots, jacks, and all the odd bits
to mount just about any PC board to anybody's panels. "Stooge" brackets work
great on Frontpanelexpress panels, too!
As you can tell I am a big fan, satisfied customer and repeat buyer! Others
on this list will tell you the same thing. MOTM-900 will work fine with the
CGS boards I have seen. I only have the CGS29 and CGS38 boards so far, but
they'll mate up to a 900 without issue. Others more qualified to speak can tell
you about compatibility with other CGS boards. I would guess there is no
issue at all.
Peace.
Tom Farrand
[Non-text portions of this message have been removed]