Hello
Ken mentions is his notes that if a higher value cap is used for the CX to place approx a 100 ohm resistor between the TL074 Pin 14 and Pin 3 of the first 4052, I used the .1uf polypropylene caps Richard Brewster mentioned on this forum (i am going to drop Richard's name alot cause I pretty much listen to every suggestion he has) anyways,,,
The trace from Pin 14 of the TL074 to Pin 3 of the 4052 goes thru one side of a 10K resistor, i just want to confirm that I should place this resistor inbetween the one end of the 10k resistor and Pin 3 of the 4052.
Thanks
Chris
[Non-text portions of this message have been removed]
Ken mentions is his notes that if a higher value cap is used for the CX to place approx a 100 ohm resistor between the TL074 Pin 14 and Pin 3 of the first 4052, I used the .1uf polypropylene caps Richard Brewster mentioned on this forum (i am going to drop Richard's name alot cause I pretty much listen to every suggestion he has) anyways,,,
The trace from Pin 14 of the TL074 to Pin 3 of the 4052 goes thru one side of a 10K resistor, i just want to confirm that I should place this resistor inbetween the one end of the 10k resistor and Pin 3 of the 4052.
Thanks
Chris
[Non-text portions of this message have been removed]