Cgs synth

Actually, now that I think about it, when you move the switch, you release
the hold line, so it's free to continue. Mind you, the switch needed
prelacing anyway. The wrong switch could damage the chip.

Ken

>I replaced the Shorting Rotary with a Non-Shorting and I still get the
>same thing....
>
>Anyone have any ideas??
>
>
>
>--- In cgs_synth@yahoogroups.com, sasami@... wrote:
>>
>> Yes, use a non-shorting rotary. As its, you are causing a connection
>between
>> a high and a low at the point of chaninging, and anything could
>happen. As a
>> rule, always use break before make switches.
>>
>> Ken
>>
>> >Last night I finished the Burst Generator, everything seems to work
>> >fine except sometimes when I am switching pulses my Burst Gen will
>> >automatically set off a series of pulses, this seems to only happen
>> >once if the pulse rotary is switched after the manual trigger or trig
>> >jack have been applied.
>> >
>> >Anyone have any ideas, the one thing I was unsure of is I used a
>> >Shorting Rotary, should I be using a Non-Shorting rotary, could that
>> >be the problem...
>> >
>> >Thanks
>> >Chris
>> >
>> >
>> >
>> >
>> >
>> >
>> >
>> >The CGS Modular Synth home page: http://www.cgs.synth.net/
>> >
>> >Yahoo! Groups Links
>> >
>> >
>> >
>> >
>> >
>> >
>> >
>> >
>> _______________________________________________________________________
>> Ken Stone sasami@... or sasami@...
>> Modular Synth PCBs for sale <http://www.blaze.net.au/~sasami/synth/>
>> Australian Miniature Horses & Ponies <http://www.blaze.net.au/~sasami/>
>>
>
>
>
>
>
>
>
>
>The CGS Modular Synth home page: http://www.cgs.synth.net/
>
>Yahoo! Groups Links
>
>
>
>
>
>
>
>

_______________________________________________________________________
Ken Stone sasami@... or sasami@...
Modular Synth PCBs for sale <http://www.blaze.net.au/~sasami/synth/>
Australian Miniature Horses & Ponies <http://www.blaze.net.au/~sasami/>