Hi all,
i just finished the PCB and the front panel for CGS01 -- The
Frontpanel design is like the one found in this Group, and
is seen here: http://diy.czmok.de/23.0.html
Regarding this setup, i need some help regarding the wirings.
A, A/2, A/4, A/8 is clear, same applies to IN A, IN B.
My question is, how the Bypass/Prescale Switch is installed,
same applies to Divider/Multip. Mode and PRESC(ale) DIV 3/7/5.
Expecially how the pots on the right side are connected is also a
question.
Last but not least, how to run which connection prewired so that the
rotary is not needed.
Many many thanks in advance for helping me out.
--jan
i just finished the PCB and the front panel for CGS01 -- The
Frontpanel design is like the one found in this Group, and
is seen here: http://diy.czmok.de/23.0.html
Regarding this setup, i need some help regarding the wirings.
A, A/2, A/4, A/8 is clear, same applies to IN A, IN B.
My question is, how the Bypass/Prescale Switch is installed,
same applies to Divider/Multip. Mode and PRESC(ale) DIV 3/7/5.
Expecially how the pots on the right side are connected is also a
question.
Last but not least, how to run which connection prewired so that the
rotary is not needed.
Many many thanks in advance for helping me out.
--jan