I'm having strange voltages coming out of my Gate Sequencer's outputs.
The LEDs light normally as it goes around 1~8, and I do not have the
rotary knob hooked up. The clock is a Blacet Binary Zone (50% duty
cycle) which runs at +15v, although I tried it attenuated down to +10v
with no change in the problem.
Here's what comes out of the outputs:
FULL: rests at about +1v, jumps up to about +12.5v when ON
PULSE: always at +13.5v no matter what
If I run the FULL output thru a Blacet Mixer/Processor to shift the
voltage down (with the Bias control) it then works OK, but the PULSE is
*always* high.
Any hints or places in the circuit I can check voltages? I have a
digital meter but no scope.
Andrew
The LEDs light normally as it goes around 1~8, and I do not have the
rotary knob hooked up. The clock is a Blacet Binary Zone (50% duty
cycle) which runs at +15v, although I tried it attenuated down to +10v
with no change in the problem.
Here's what comes out of the outputs:
FULL: rests at about +1v, jumps up to about +12.5v when ON
PULSE: always at +13.5v no matter what
If I run the FULL output thru a Blacet Mixer/Processor to shift the
voltage down (with the Bias control) it then works OK, but the PULSE is
*always* high.
Any hints or places in the circuit I can check voltages? I have a
digital meter but no scope.
Andrew