Building a Morph-Lag, and have two questions:
1) The PCB specifies that C1 (see schemo below) is a "5uF MYLAR". Will a standard poly cap work OK? Or some other type?
http://www.wiseguysynth.com/larry/schematics/Morph-Lag/Morph-Lag.gif
2) If I was to use 500k pots for the Attack & Decay (instead of the 1M specified), would that just limit the max lag to a shorter time?
thanks :)
Drew
_________________________________________________________________
Hotmail: Trusted email with Microsoft�s powerful SPAM protection.
http://clk.atdmt.com/GBL/go/177141664/direct/01/
[Non-text portions of this message have been removed]
1) The PCB specifies that C1 (see schemo below) is a "5uF MYLAR". Will a standard poly cap work OK? Or some other type?
http://www.wiseguysynth.com/larry/schematics/Morph-Lag/Morph-Lag.gif
2) If I was to use 500k pots for the Attack & Decay (instead of the 1M specified), would that just limit the max lag to a shorter time?
thanks :)
Drew
_________________________________________________________________
Hotmail: Trusted email with Microsoft�s powerful SPAM protection.
http://clk.atdmt.com/GBL/go/177141664/direct/01/
[Non-text portions of this message have been removed]