Hi all,
I'm new to the group as this is really my first CGS build. I have built lots of diy modules and I have learnt alot doing so, but I am no electronics engineer.
When placed in cycle the module appears to work perfectly. It cycles between 0 and around +6v. All the pots work as they should including the EXP switches and Voltage Control.
But when I trigger the module, it slews from around -13v up to +5v and then back again. The End out idles at +5v and pulses to ground at the end of the cycle. I can't seem to really slew anything at the 'In' either.
I have triple checked orientation of the parts on the board and the wiring. I'm 90% sure the transistors are the right polarity and I haven't been able to find any broken traces or shorts.
I will continue searching the board for mistakes I might have made. If anyone has experienced this before or can point me in the right direction, any info would be most appreciated.
Cheers
Dean
I'm new to the group as this is really my first CGS build. I have built lots of diy modules and I have learnt alot doing so, but I am no electronics engineer.
When placed in cycle the module appears to work perfectly. It cycles between 0 and around +6v. All the pots work as they should including the EXP switches and Voltage Control.
But when I trigger the module, it slews from around -13v up to +5v and then back again. The End out idles at +5v and pulses to ground at the end of the cycle. I can't seem to really slew anything at the 'In' either.
I have triple checked orientation of the parts on the board and the wiring. I'm 90% sure the transistors are the right polarity and I haven't been able to find any broken traces or shorts.
I will continue searching the board for mistakes I might have made. If anyone has experienced this before or can point me in the right direction, any info would be most appreciated.
Cheers
Dean