I dont think a 10 meg imp. is going to bother the measurement too much.
On 2012-12-28 6:19 PM, "Richard Brewster" <pugix@...> wrote:
**
Easy, if you have a voltmeter. Listen to the output and add 1V to the CV
input. If it jumps up an octave you've nailed it. Better yet use a
frequency meter on the output. Sometimes I patch the output of a module
I want to frequency check through a comparator (CGS quad logic works
well) and measure that, because frequency meters often load down the signal.
Richard Brewster
http://pugix.com
On 12/28/12 5:07 PM, meech wrote:
> I think i have mine tuned to 1V/O with the CV pot at about 10 ...
> ------------------------------------
>
>
[Non-text portions of this message have been removed]