You could try removing it from the panel without desoldering it. That would allow you to flex it a little, and to gain access to the other side.
KenOn Thu, Dec 10, 2015 at 10:10 AM, neil.a.Baldwin@... [cgs_synth] <cgs_synth@yahoogroups.com> wrote:I've visually checked all the resistors, all the diodes are the correct orientation, all polarised caps are correct. The only thing that I can't check is all the non-polarised caps as I mounted some of them with the legend facing into the back of the panel so can read them in situ. Are any of those critical to the problems I'm seeing?I fear I'm going to just have to desolder all of the bus wiring and dismantle the whole thing. It's impossible to debug it while it's not assembled but it's also physically impossible to debug it while it's assembled in the panel - just not enough room between the boards to get tools in.If there's anything you can suggest Ken it might save me a lot of extra work and a horrible desoldering job.
--