Thanks guys
It turns out that the problem was a bad thru connection at the Molex connector itself
There are traces on both sides of the board and the thru plating was not working or stopped working! I need a right angled header to make sure both sides are adequately soldered to the traces.
DIY can be Magically effortless sometimes and a real enigma the next.
Sent from my iPhone
On 11 Oct 2018, at 22:53, Richard Brewster pugix@... [cgs_synth] <cgs_synth@yahoogroups.com> wrote:
If I were building this board, I would draw my own schematic from it. I wouldn't publish a schematic that isn't publicly available, but if you bought the board I feel it's within your rights to understand it.
I see this board is currently available from Modular Addict.
The build guide link is broken on modular addict, but you can get the information you need from Elby.
Richard Brewster
On Wednesday, October 10, 2018, 10:50:50 PM EDT, Ken Stone otherunicorn@... [cgs_synth] <cgs_synth@yahoogroups.com> wrote:
No. Peter G didn't release it.
On Thu, Oct 11, 2018 at 3:54 AM Mike Burnham mikejburnham@... [cgs_synth] <cgs_synth@yahoogroups.com> wrote:
Is it possible to get a schematic for the full LPG BOARD
I am building 2 on one chassis piggy backing the power from one to the other. It worked fine for 10 minutes then dropped the +15v rail.
without the traces or schematic it's hard to troubleshoot
Sent from my iPhone
--