Cgs synth

>"...First, decreasing the size of the input divider resistor on the CV
>input section, 1K in Ken's circuit, increases the range of the
>frequency control. I put 2.2K in parallel with the 1K resistors, or
>you can swap the 1K with a 680 ohm resistor."
>
>Where are those on the circut board?

The 1k is the one neares to the power connector end of the board, running
width-ways, and right next to the 220k input resistors.

> And the resonance pot seems to jump the resonance around.
>It goes up as you turn it, then down, stops, then goes up again.
>What's that about?

Overdrive. A lot of us love that. You are sending the filter into a chaotic
mode. If you don't like it, put a 1k trimmer in line with the pot, then
adjust it for the desired maximum with the pain pot all the way up.

Kem
_______________________________________________________________________
Ken Stone sasami@... or sasami@...
Modular Synth PCBs for sale <http://www.blaze.net.au/~sasami/synth/>
Australian Miniature Horses & Ponies <http://www.blaze.net.au/~sasami/>