Thanks Romeo. I see in the Electronotes the sync output is taken from near the saw out,
but I don't know how to precissely do that on the CGS VCO... I don't know wich is the best
point to take the signal out as a sync output and if a resistor or something is needed
(remember I don't have a clue about electronics =:)
but I don't know how to precissely do that on the CGS VCO... I don't know wich is the best
point to take the signal out as a sync output and if a resistor or something is needed
(remember I don't have a clue about electronics =:)
--- In cgs_synth@yahoogroups.com, "Fahl, Romeo" <rfahl@e...> wrote:
> It's basically just a sawtooth output, centered around 0V, on the Electronotes VCO.
>
>
> %-----Original Message-----
> %From: Fernando [mailto:fdi@r...]
> %Sent: Tuesday, June 15, 2004 11:43 AM
> %To: cgs_synth@yahoogroups.com
> %Subject: [cgs_synth] VCO sync out?
> %
> %
> %Hi,
> %
> %I'd like to know if there is a simple way of implementing a
> %sync output on the CGS VCO.
> %I see the ENS-76 op.1 has a sync out, but I don't know how to
> %translate it to our CGS VCO.
> %
> %Thanks,
> %
> %Fernando
> %
> %
>