Cgs synth

I see some mention in the archives of someone thinking about building 2 of
these in parallel and Ken mentions to use the reset function to keep them in
sync. Did anyone ever get around to building it this way?

I would like to build 2 units to run parallel in only sequencer mode. Im
thinking to cut out all the ins and out on individual stages and adding a
length selector so i can choose 1-8 stages. Outputs will be 1 gate, 1 CV,2
gate, 2 CV. Ideally it would be nice to also build some kind of skip
function into the stages but i can do without this.

I also see mention in the archives again to link them together with another
switch but i think ill pass on that amount building complexity lacking more
concrete instructions.

Has anyone got any advice on this? Im not the most technically adept
builder. I thinking to use smaller style motm knobs and mount into 2 unit
.com panel.

Also can someone point me to a more detailed explanation of the new
programmer?

Regards
--
Wasubot
----------------------------
Notes: Special Sequence Mixed For Dancing


[Non-text portions of this message have been removed]

I haven't built a 16 step Seq Switch, however it's farily easy link
up two eight steppers for 16 steps. You just need a few helper modules.

I run the ouptut of the first into the mix input of the second, and
use a third 2-step sequencer (running at /8) and inverter to turn
each switch on and off every eight steps. The inhibit inputs make all
outputs go low on a Seq Switch, so the gate outputs work correctly as
well.

A helper module that consisted of a resettable /8 flip flop and
inverter would make it even easier to link two of them.

Regards,

Michael Ford

--
http://www.metalbox.com