Yahoo Groups archive

Cgs synth

Index last updated: 2026-04-28 23:16 UTC

Thread

Gate Seq - no pulse at output

Gate Seq - no pulse at output

2009-05-17 by synthwick

I'm getting full out w/ either switch position, and from either output (both pulse and full/mix) on my gate seq. I'm guessing it's the 4081, but I don't have a spare to test it.
would a bad 4081 still allow the signal to pass? (just trying to be sure I'm on the right track before I make the trek to the electronics store)

thanks

Re: Gate Seq - no pulse at output

2009-05-25 by synthwick

Well, it was an IC, but not one of them on the buffer board. It was the 072 on the main pcb, clock input. The 4017 on the main board worked fine. strange...
Show quoted textHide quoted text
--- In cgs_synth@yahoogroups.com, "synthwick" <synthwick@...> wrote:
>
> I'm getting full out w/ either switch position, and from either output (both pulse and full/mix) on my gate seq. I'm guessing it's the 4081, but I don't have a spare to test it.
> would a bad 4081 still allow the signal to pass? (just trying to be sure I'm on the right track before I make the trek to the electronics store)
>
> thanks
>

Move to quarantaine

This moves the raw source file on disk only. The archive index is not changed automatically, so you still need to run a manual refresh afterward.