Rhodes Chroma Polaris group photo

Yahoo Groups archive

Rhodes Chroma Polaris

Index last updated: 2026-04-28 23:17 UTC

Message

Re: [chromapolaris] Polaris stubborn tuning problems

2015-07-10 by klosmon

On 7/9/2015 4:51 PM, Bob Grieb bobgrieb@... [chromapolaris] wrote:
> Until Paul jumps in, I guess anyone can throw out ideas,
> so I will...
>
> The output of each synth channel goes through a 4053 MUX to create
> main out and alt out.   Did you replace those on the two offending
> voices?
Yes, that was part of the "all ICs" on the offending voices.
>    Also, did you scope the signal coming out of the
> "tune buffer"   and also the signal at the output of the 1489 Z46?
> I know that those are not specific to particular voices, but maybe if
> they are bad, some voices could be more affected than others?
Yah, the ZCD signal looks the same for all oscillators.

Tomorrow I start measuring resistors & checking traces.
Will also look further back in the data lines to see if any disturbances 
there might be causing some trouble.
~G

>
> Bob
>
> ------------------------------------------------------------------------
> *From:* "klosmon klosmon@... [chromapolaris]" 
> <chromapolaris@yahoogroups.com>
> *To:* chromapolaris@yahoogroups.com
> *Sent:* Thursday, July 9, 2015 5:04 PM
> *Subject:* [chromapolaris] Polaris stubborn! tuning problems
>
> Currently working on a Polaris that was severely mistreated.
> Replaced the membrane panels, several pots; upgraded the ROMs; tuned &
> scaled the power supply, DAC, CPU and voice board per the service manual.
>
> Two voices (3 and 5) will not pass tune. Re-enabling them shows that
> Oscillator B on both voices scales sharp towards the upper part of the
> keyboard;  also, when playing the filter resonance from the keyboard,
> those two voices are out of tune with the rest.
>
> What I've done so far:  swapped out ALL ICs on the two offending voices
> -- no change.
> Swapped out all the sample/hold caps and oscillator timing caps on the
> two offending voices -- no change.
> Replaced the four ICs (Z60 - 63) in the sample/hold control circuit --
> no change.
>
> At this point, I'm out of ideas as to why these two voices are behaving
> this way.
> All memory functions, internal and external controls, and other synth
> features are working correctly on all voices.
>
> Any suggestions?
> Thanks.
> ~GMM
>
>
> ------------------------------------
>
> ------------------------------------
>
>
> ------------------------------------
>
> Yahoo Groups Links
>
>
>     (Yahoo! ID required)
>
> chromapolaris-fullfeatured@yahoogroups.com 
> <mailto:chromapolaris-fullfeatured@yahoogroups.com>
>
>
>
>
>
>

Attachments

Move to quarantaine

This moves the raw source file on disk only. The archive index is not changed automatically, so you still need to run a manual refresh afterward.