Message
Re: [colorvision_group] Spectro not reading properly
2007-02-18 by CorrPro96@aol.com
In a message dated 2/18/07 10:53:04 AM, mkraus1044@... writes:
I am using PrintFix Pro v2.0.
My program and spectro have been working fine up until this am.
Actually made a good set of profiles yesterday. Today when I use the
spectro to measure a target and look at the meausred values, the colors
are way off. I have white balanced before I did this as usual. I look
at my prior measured targets and they look fine, but when I try to make
a new one today, even using the same paper as I used yesterday, colors
are way off. Is there a setting I perhaps have wrong? Is there a way
to determine if it is reading properly? Thanks.
Matthew Kraus
How was your nozzle check? Print the preliminary test charts in the software.
Richard (Brooklyn)