Datacolor User to User Support Group.

Which version of Colornavigator are you using? The latest version - 6 - 
supports the Spyder3, but not gray balancing and something else, while the 
older versions did support Spyders but not on 64bit Win 7.

Bob Frost

--------------------------------------------------
From: "Rollin H" <rhill3@...>
Sent: Saturday, September 03, 2011 8:05 PM
To: <datacolor_group@yahoogroups.com>
Subject: [datacolor_group] Profile Not Loaded

> I have a Win 7, 64 bit system with dual monitors each installed on its own 
> graphics card.  One monitor is a Dell U2410 and the other is an Eizo 
> CG222W.  I have adjusted the Dell using the monitor controls and the Eizo 
> using the utility provided by Eizo which uses the Spyder3 as the measuring 
> device.  I then ran the Spyder3 Pro software to build a profile for each 
> monitor.
>
> When I boot, the Sypder3 software attempts to load the profiles to the LUT 
> and the one for the U2410 monitor loads but the one for the CG222W gets 
> and error indicating it could not be loaded.
>
> Any ideas on what is happening and what I need to do?  Is it possible that 
> The Spyder3 software and the Eizo ColorNavigator are in conflict?  If so, 
> then is there a way to have the Spyder3 software support one monitor but 
> not the other?  The monitor looks good after using the Eizo ColorNavigator 
> to set the values for brightness, contrast, color, etc.
>
>
>
> ------------------------------------
>
> Yahoo! Groups Links
>
>
>