Datacolor User to User Support Group.

(Equipment: Spyder3 Elite)

I know that I am suppose to reset my monitor to factory defaults before each 
re-calibration but am I also suppose to also "Unload" (if that is a proper 
term) my prior profile that was loaded into my graphics card before doing 
the re-calibration?

If the answer is yes, then is there a way to "unload" it without having to 
reboot since rebooting makes the Spyder3 Elite utility program complain 
about waiting 30 minutes for the monitor to warm up even though the monitor 
has already been on for hours and it was only a reboot?

Thanks in advance,
Thomas

Neither is necessary. The software unloads the calibration LUTs  
automatically, and the presets from your last calibration ( if you  
were satisfied with your previous calibration) are fine for this trip  
through as well.

C. D. Tobie
Global Product Technology Mngr.
Digital Imaging & Home Theater
Datacolor.com
CDTobie@...

On May 1, 2009, at 11:36 PM, "Rebel PPC" <maildumpyyahoogroups@... 

 > wrote:

> (Equipment: Spyder3 Elite)
>
> I know that I am suppose to reset my monitor to factory defaults  
> before each
> re-calibration but am I also suppose to also "Unload" (if that is a  
> proper
> term) my prior profile that was loaded into my graphics card before  
> doing
> the re-calibration?
>
> If the answer is yes, then is there a way to "unload" it without  
> having to
> reboot since rebooting makes the Spyder3 Elite utility program  
> complain
> about waiting 30 minutes for the monitor to warm up even though the  
> monitor
> has already been on for hours and it was only a reboot?
>
> Thanks in advance,
> Thomas
>
>
>
> ------------------------------------
>
> Yahoo! Groups Links
>
>
>

C. D. Tobie Wrote:

>Neither is necessary. 

Thank you for the reply.  

Best Regards,
Thomas