Emax

No I don’t have a process for updating banks  with HxC because I don’t have HxC.
I have (and sell / install) the SCSI chip upgrade for Emax.

But I have a pretty good understanding of how Emax (at least the electronics of it) work.

You never saw “Updating” like in the PDF because once the Emax has been made SE (probably many years ago), you would never see this message again (unless you removed the parameter EEPROM, so it no longer had the bit set).
The special disk checks for SE bit in Parameter EEPROM, and if it’s there (meaning the update was already done previously), the disk just boots like any normal disk…

-T



On Dec 13, 2015, at 5:13 AM, yusteromerooscar@... [emax] <emax@yahoogroups.com> wrote:

Ok, for me was very confuse because I expected a message updating firmware of the emu emax, in the PDf is a different process..you know...



Than, next steps is rebuild each bank, do you have experience with this?

Thank you very much for your help.





[Non-text portions of this message have been removed]